- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am not sure what the appropriate location to post this is, but this category makes the most sense. I am creating a FPGA and want to include the JHL8540 S RH4Q (Thunderbolt 4) as a way to program the FPGA. I cannot find a model for footprint, nor schematic. Where can I find models so I can upload them to Altium and finish my design? Or at the very least have a datasheet that has the dimensions so a schematic, pinout, footprint and 3D model can be made.
Thank you,
Drew
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @MATRIX7878,
Oh, my apologies, thank you for reminding me, I had it pending but I forgot to answer.
Here, you can check the document I have mentioned:
But, it is required a Premier account to get access to that document, you can check this link:
Best regards,
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @MATRIX7878,
Thank you for contacting Intel Embedded Community.
You may check the document #614469 - Thunderbolt Maple Ridge DP Collateral -rev1.1-3 in RDC.
It contains everything related to design with this controller.
Best regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
It has been a while since I heard from you. Is there any update for me?
Thank you,
Drew
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @MATRIX7878,
Oh, my apologies, thank you for reminding me, I had it pending but I forgot to answer.
Here, you can check the document I have mentioned:
But, it is required a Premier account to get access to that document, you can check this link:
Best regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Thank you for responding. I will try to get a Premier account so I can continue to build my board.
Thank you,
Drew
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page