Embedded Intel® Core™ Processors
Communicate Intel® Core™ Hardware, Software, Firmware, Graphics Concerns
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
1327 Discussions

XL710 NVM Blank EEPROM Programming

idata
Employee
‎02-10-2017 01:30 PM
2,109 Views

In the meantime, we were able to get our new board mostly working by taking an NVM eeprom chip off of an Intel X710-DA2 adapter we had.

We tried using nvmupdate64e on our blank eeprom, but it says "Access Error" (and yes, write protect is disabled).

- Are there other tools available to program the NVM when blank?

- Do we need a separate EEPROM programmer to program it breof ir goes on the board?

- Can it be programmed via JTAG? if so are there tools for that?

Thanks

0 Kudos

Link Copied

1 Reply
CarlosAM_INTEL
Moderator
‎02-13-2017 06:42 AM
1,169 Views

Hello, ScottCarsley:

Thank you for contacting Intel Embedded Community.

It is important to let you know that the Intel(R) Ethernet Converged Network Adapter X710-DA2 consultations should be addressed to the https://communities.intel.com/community/wired Intel Wired Ethernet Forum Community.

We hope that this information may help you.

Best regards,

Carlos_A.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.