eepromARMtool src

[MPodl]

I'm looking for the eepromARMtool source so we can

program the iNVM of the i210 on one of our

networking switch products. We need it to run

in copper flash-less mode(devid 157b). The parts

are currently blank(devid 1531).

Thanks,

Mark

--

mailto:podlipec@avaya.com podlipec@avaya.com

[CarlosAM_INTEL]

Hello, Leo_A:

Thanks for your reply.

In order to help you, we will contact you via email.

Best regards,

Carlos_A .

[idata]

Hello. Could you please send me the link for the eepromARMtool source code? I need to attempt cross compilation for ppce5500, in case pre-programming does not succeed on our board arriving soon. Thanks.

[CarlosAM_INTEL]

Hello, ewaugh:

Thank you for contacting Intel Embedded Community.

In order to help you, we will contact you via email.

Best regards,

Carlos_A.

[idata]

Hi Carlos,

I have not received an email. Could you please advise?

Thanks.

[CarlosAM_INTEL]

Hello, ewaugh:

Thanks for your update.

We have sent again an email to you.

Please check your junk and/or spam inboxes to verify that you receive this new communication.

We hope that you will receive it.

Best regards,

Carlos_A.

[ELin21]

Hi Carlos,

I also need the eepromARMtool sources.

Can you provide a copy of it to me?

[CarlosAM_INTEL]

Hello, Eric_Lin :

Thank you for contacting Intel Embedded Community.

In order to help you, we will contact you via email.

Best regards,

Carlos_A.