Ethernet Products
Determine ramifications of Intel® Ethernet products and technologies
5232 Discussions

Can I connect the X4DACBL3 to the HP 5412zl module j9536a?

TZido
Beginner
1,515 Views

I have install a XL710-QDA2 on a supermicro server and have setup the NIC with 4x10 through the EFI utlity QCU.

I would like to connect the server to my HP 5412zl switch, but so far no luck just "port status = down"

So my question is:

Can I connect the X4DACBL3 to the HP 5412zl module j9536a?

0 Kudos
2 Replies
idata
Employee
480 Views

Hi tzidore,

 

 

Please contact HP if there's needed configuration to establish connection with similar setup. I'll also check internally if there's known report regarding your issue and will update this thread as soon as possible.

 

 

regards,

 

Vince
0 Kudos
idata
Employee
480 Views

Hi tzidore,

 

 

I've noticed you've reported your issue thru our web portal and already received response.

 

 

You may also look into your switch software version as mentioned in HP article( page 2) to have at least version 15.02 or higher (1m to 7m), 15.05 (10m to 15m) for SFP+ connection

 

 

HP article Link below:

 

http://h20565.www2.hpe.com/hpsc/doc/public/display?sp4ts.oid=4293022&docLocale=en_US&docId=emr_na-c02604897

 

 

regards,

 

Vince
0 Kudos
Reply