I350 MAC to MAC and PCIE x1 to 4 SGMII ports

[mihailo]

Hello,

I have a few questions regarding the Intel I350 Ethernet controller:

1. Can I establish a MAC to MAC link via SGMII without an Ethernet PHY?

2. I read in the datasheet that I can connect the I350 module to a PCIe x1 slot. I intend to use the I350 as a bridge in the following configuration: PCIe x1 on one side and 4 SGMII channels on the other. Is this feasible?

Additionally, I'm unclear about the PCIe function. I couldn't find specific information about its function.

Could you please refer me to an application note or any other resource where I can find useful information?

Best regards,
Mihailo Grahovac

[Simon-Intel]

Hi Mihailo,

Good day!

I believe you posted the same query in in the below community forum.

https://community.intel.com/t5/Ethernet-Products/I350-MAC-to-MAC-and-PCIE-x1-to-4-SGMII-ports/m-p/1608427#M38517

Since your issue is related to SOM board and SGMII, we have a separate forum where you can get further assistance.

Kindly use the below link and submit your request.

https://community.intel.com/t5/Embedded-Connectivity/bd-p/embedded-networking-connectivity

Please don’t hesitate to contact us for any further assistance.

Thank you for using Intel products and services.

Regards,

Simon

[CarlosAM_INTEL]

Hello,  @Simon-Intel:

Thank you for contacting Intel Embedded Community.

We need to clarify that this forum is not related to an Intel Embedded Platform.

Due to this, the customer request is out of our scope of support.

Please consider this information when you provide the previous suggestion, or transfer any forums to the channel that you mentioned in your previous communication.

Best regards,

@CarlosAM_INTEL.