Simple NIOS Max 10 ethernet

[Altera_Forum]

I'd like to implement a very simple ethernet interface for low-speed data transfer to replace RS232 communication. I have used Lantronix before, but that is still more complicated than what I need. I don't need to host a web page, but that might be nice in the future. 

 Here are some loose requirements:   - No operating system is desired.   - TCP/IP stack handled in C code for minimum development time  - Cheap PHY chip (or even better, no phy chip). Suggestions here?  - No DDR off-board memory  - 10/100 required. Gbit ethernet okay, but I don't want to lock myself into an expensive phy chip or a device that has transceivers  - Able to be used by a higher-end (bigger) Max 10 chip, perhaps the 10M40  - No licenses or OSes to purchase. BTW, is the triple speed ethernet IP provided by Intel free?  I saw the simple socket reference design. This is close to what I need, but I don't want DDR memory. I could change the Qsys project to use on-board memory instead, but I'm not sure how much it really needs. The Max 10 runs out of memory pretty quickly.  I would really appreciate any help. Thanks!

[Altera_Forum]

I found the Arrow DECA board, which looks to be designed by Terasic. It has a 10/100 phy. $3 in production, so probably too fancy, but it is cheaper than the 1GBit phys that are being put on some other eval boards. 

 Good news is that it has a Max 10, and probably some reference designs to get started. Here's the link if anyone is interested:  https://www.arrow.com/en/reference-designs/deca-development-kit-based-on-the-10m50daf484c6ges-max-10-fpga/178fffd04d89cbb578855555cb159a1a

[JFarm]

I am also looking for a simple Ethernet Interface for the Arrow DECA board that does not use DDR memory. Even if it just for the Max 10 and a different PHY would work.

I would really appreciate any help. Thanks!