- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Intel FPGA boards often have the USB Blaster logic on the development board itself. In this way a separate programmer is not required. We have this situation where more than five USB Byte Blaster II programmers became damaged during systems testing. It is thought that if we have the byte blaster logic on the prototype board itself, it will save a lot of resource on the long term by simplifying many other tasks and mitigating some of the risks that exist with the Byte Blaster IIs being used at present.
Usually a small Max series device is seen to implement the configuration logic. Does Intel/Altera provide detailed instructions on how to go about creating the on-board Byte Blaster II using a Max device as found on their development boards?
- Tags:
- configuration
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Any update? I only want to have onboard programmer for our custom PCBs so ByteBlaster is not require anymore.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi gyuunyuu,
On-Board Intel FPGA USB Download II IP is licensed.
Therefore, the On-Board Intel FPGA USB Download II design/project file and project instruction will be provided after you purchase the license.
If you like to purchase this On-Board Intel FPGA USB Download II, please let me know and I will contact you via private message.
Regards,
Matt
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ok, since the onboard byte blaster has present on so many different development boards, I had expected that it should not be too difficult to get a hold of it.
How much does the license and reference design cost?
- Tags:
- ok
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi gyuunyuu,
Please contact me via private message.
I'll continue support you vie private message.
Thanks.
Matt
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please explain how this private message thing works. I don't know how it works on these new forums.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I already sent you a private message.
Please go to top right (refer picture below) ---> go to inbox.
Thanks
Regards,
Matt
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Any update on this? I have still not been contacted by you about this.
![](/skins/images/D2683F18326913BBA0436CB7114DD569/responsive_peak/images/icon_anonymous_message.png)
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page