FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
6673 Discussions

WM8731 SOPC 2 Wire SPI Interface

Altera_Forum
Honored Contributor II
‎04-24-2008 10:14 PM
1,174 Views

Hi, I've got a board here , Altera Cyclone II development board http://www.altera.com/products/devki...yc2-2c20n.html... 

 

I'm trying to communicate over SPI with the onboard WM8731 chip. The schematic on the data sheet shows that one of the wires (MODE) of the SPI interface is wired to ground. Therefore, we are supposed to use a two-wire SPI protocol, however all that SOPC has is a three-wire SPI. Does anyone know if there is a way to either a.) reconfigure the SPI that we have or b.) download a new SOPC module. 

 

I did some searching and it appears as though two-wire SPI might be I2C although i'm not too sure about this. 

 

If anyone could point me in the right direction that'd be much appreciated.
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎04-24-2008 10:34 PM
461 Views

In the board schematics, the signal names i2c_sdat and i2c_sclk are written very clearly to the codec control lines. Thus I think, there's no doubt left regarding the interface type.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.