FPGA Intellectual Property
PCI Express*, Networking and Connectivity, Memory Interfaces, DSP IP, and Video IP
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
6673 Discussions

master other than NIOS cpu

Altera_Forum
Honored Contributor II
‎02-27-2009 04:42 AM
1,187 Views

hi all, 

 

I am using Quartus SOPC builder to make a system. But I am using my microcontroller(8051) as cpu. For that if i connect a single slave, it is working fine but if connect more than one, none of them work. What may be the problem?  

 

Thank you.
0 Kudos

Link Copied

2 Replies
Altera_Forum
Honored Contributor II
‎06-10-2009 10:07 AM
490 Views

it's a good question, I'm guess this room almost amateurs so they can't answer you :) !!!

0 Kudos
Copy link
Altera_Forum
Honored Contributor II
‎06-10-2009 02:50 PM
490 Views

1 - Are you obeying the waitrequest rule? 

2 - Is your address map correct? 

 

What is the failure mode? In what way is it "not working"? 

 

Jake
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.