- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I use the TSE IP core in my design.
when I software reset the IP core, sometimes it is not automatically cleared, and sometimes it works fine. What is the problem? I use it in loopback mode without a PHY device. I only want to check if my simple TSE device works fine.Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I remember there is one issue related to the software reset of tse mac when i go over the errata document. You can double check the document.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I can not find the errata document.
Would you tell me the linked website. or send me a copy. my e-mail: draculaor@gmail.com I use TSE v8.0- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hi,
the link is http://www.altera.com/literature/lit-es.jsp where you can see "MegaCore IP Library Release Notes and Errata" and check the TSE MAC part. regards,
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page