- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have Cyclone 10 GX Dev Kit FPGA and I am using example design systemmax10 project to configuration of temperature sensor over i2c bus , I try to read data from EM2130 but find out EN_GROUP1 pin is enable, So created another project to program Max 10 (sys ctrl) but cannot find on JTAG chain. How will I access Both MAX10 devices on JTAG.
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
This case is duplicated from case 05545966. I am closing this case and will focus on case 05545966.
regards,
Farabi
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page