DE1 Borad for FIR filter

FPGA, SoC, And CPLD Boards And Kits

FPGA Evaluation and Development Kits

DE1 Borad for FIR filter

1,181 Views

I am Using DE1 board for FIR filter verification.

I did fir code in verilog and with the help of DSP builder i want to verify the functionality of the code.

So i connected some random signal generation in MATLAB simulink and that i connected to the filter bolck(this is done by importing HDL block).

In Matlab window the results are coming, if i want to verify it on a oscilloscope, how can i connect the oscilloscope externally.

The matlab simulink is shown in the figure.

98 KB

Link Copied

0 Replies

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.