FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
5279 Discussions

DE2-115 Programming: No hardware detected

Altera_Forum
Honored Contributor II
1,426 Views

Hello, 

i have 3 Developement boards. With the first 2 i don't have problems to program. Since i adoped the project from a collaborator witch announced, i don't know if he did something i don't know to activate the programmer. Now, if i try to program the 3rd board, the programmer doesn't detect the hardware, although all is the same (i think): 

- Same board 

- Same Hardware Settings (All jumpers the same position, board is powered, USB cable connected, Switch on Run: here i don't know exactly why it isn't on Prog, but the other boards can be programmed with a jic file) 

- Same PC (Win 7 Pro 64) Of coarse the driver is the same. 

Has any one an idea?
0 Kudos
2 Replies
Altera_Forum
Honored Contributor II
281 Views

Hi there,  

 

Could you first check if Altera USB-Blaster is detected properly ? You can check this in Quartus Programmer or the device manager from your PC.  

 

I'm also a bit confused about the file format and the type of programming method you mentioned, despite all the settings are the same on these 3 DE2-115 boards. Is the RUN/PROG switched to RUN or PROG to program .jic, .sof, or .pof ? 

 

David from Terasic
Altera_Forum
Honored Contributor II
281 Views

Hi David, 

thank you for your response. Fortunately i could now program the new board, unfortunately i don't know why... I asume, that i made something wrong while programming but i didn't recognize any differences.  

So far so good.  

As I said, my predecessor implemented the hole configuration. I now have a manual how to: generate qsys, revert (from svw) compile VHDL, generate bsp, revert, compile program since there are some changes from normal generations. 

Anyway, after converting i get a .jic file witch i can program to the board. The switch can be set on Run if i do this. I know that this isn't the straigt way you describe in the manuals. But i am not an microelectronic specialist only concerning on the firmware. (If i get no problems) We are searching a specialist in FPGA but until now we were not successful. 

Thank you anyway,  

Thomas
Reply