How to configure uart using HPS - Intel Community

FPGA, SoC, And CPLD Boards And Kits

FPGA Evaluation and Development Kits

How to configure uart using HPS

1,203 Views

Hi,everyone.

I want to trancemit calculation result of user logic using uart on DE10-NANO board.

Is it possible?

Link Copied

1 Reply

441 Views

Hi,

Yes, You can.

1.First your logic from FPGA need to communicate to HPS.

2.And HPS UART interface need to be enabled.

Here are the few links which will help in your design

https://rocketboards.org/foswiki/Projects/Datamover?_ga=2.22746235.1399421023.1533776978-779159282.1533545197

https://forums.intel.com/s/question/0D50P00003yyQ23SAE/accessing-uart-peripheral-of-hard-processor-system-hps-in-cyclone-v-soc

Best Regards,

Anand Raj Shankar

(This message was posted on behalf of Intel Corporation)

Copy link

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.