- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am new to this, and I apologize if there is already a post that addresses this (I did not find 1 when I searched). I am looking for input about if the Intel Cyclone 10 LP FPGA Evaluation Kit can be used to evaluate the 10CL006YU256I7G Cyclone 10 FPGA IC.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
Welcome to INTEL forum. FYI, intel Cyclone 10 LP FPGA board use OPN 10CL025YU256I7G and your evaluate Cyclone 10 FPGA IC is OPN 10CL006YU256I7G.
The difference in FPGA core logic capacity:
· 10CL025YU256I7G = 24,624 logic elements
· 10CL006YU256I7G = 6,272 logic elements
So, there is high chance that it’s possible to use dev kit board to test out your eval OPN. You could check further in Intel Cyclone 10 LP Available Options: https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyclone-10/c10lp-51001.pdf
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I hope all is well. We have not heard from you and I hope that my last note clears up this matter. It is not recommended to keep a Case idle too long without activities. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page