FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
FPGA community forums and blogs have moved to the Altera Community. Existing Intel Community members can sign in with their current credentials.
6477 Discussions

The issue encountered when programming the POF file into MAX10

xingyunzhidi
Beginner
‎04-26-2025 07:46 PM
415 Views

After powering on my FPGA development board, the power status LED did not light up, so I checked it and found that the issue was with the MAX10 chip. I then planned to reprogram the MAX10 using the max10_bmc.pof file located in the factory_recovery/max10_recovery directory in BTS. However, during the programming process, Quartus reported the following error: Error(209015): Can't configure device. Expected JTAG ID code 0x031050DD for device 1, but found JTAG ID code 0x020D10DD. Make sure the location of the target device on the circuit board matches the device's location in the device chain in the Chain Description File (.cdf).error.jpg

max10_bmc.zip
0 Kudos

Link Copied

1 Reply
WZ2
Employee
‎05-05-2025 07:16 PM
331 Views

May I ask which development board you are using?

Some boards require specific switch settings.

Also, could you please confirm whether the board matches the installation package you downloaded?


0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.