- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I got a Max10 Dev kit and successfully run the diag program featured with it (able to access the device through JTAG, read ADC, toggle LEDs ...) I then built a very simple project, based on the golden_top sample, it compiles but I'm unable to program it on the device. I tried it in the same way I did it with former version of Quartus (launch programmer, add sof file and then click start) but I systematically get a "failed"! :( What could be wrong? Thanks for any advice BR JyloLink Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Got it!
Autodetect then assign the sof file to the 10M50DAF484C6GES device. Sorry that I didn't find it before posting Jylo
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page