detail of altera_pcie_gui stop run

[dsun01]

Dear Inter support.

I have a PCIe project on A10, while I am not very confident that the platform is working. I decide to use the altera_pcie_gui to verify it. 

I downloaded the FPGA and driver, on win7. I believe I followed the instructions carefully, but the program still not working. 

I attached a file that describes my setup and execute procedure. 

hope someone who had run the program successfully before can give me some suggestions. 

thank you very much.

David

[Wincent_Altera]

Hi David,

There is a step by step video guide on how to run the Arria 10 AVMM DMA

https://www.intel.com/content/www/us/en/support/programmable/support-resources/fpga-training/fpga-quick-video-index.html?q=AVMM%20DMA&s=Relevancy

Can you please take a look and see if this solve your problem ?

Regards,

Wincent_Intel

[Wincent_Altera]

Hi,

I wish to follow up with you about this case.

Do you have any further questions on this matter ?

​​​​​​​Else I would like to have your permission to close this forum ticket

Regards,

Wincent_Intel

[Wincent_Altera]

Hi,

I wish to follow up with you about this IPS case.

Hoping to hear back from you so that we can proceed for next step.

Regards,

Wincent_Intel

[Wincent_Altera]

Hi David

We have not hear from you and this Case is idling. It is not recommended to idle for too long.

Therefore following our support policy, I have to put this case in close status. My apologies if any inconvenience cause

Hence, This thread will be transitioned to community support.

If you have a new question, feel free to open a new thread to get support from Intel experts.

Otherwise, the community users will continue to help you on this thread. Thank you

If you feel your support experience was less than a 9 or 10,

please allow me to correct it before closing or let me know the cause so that I may improve your future support experience.

Regards,

Wincent_Intel