FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
5152 Discussions

ethernet timeout max 10 with nichistack SRAM memory

sRama28
Beginner
200 Views

hi Intel 

 

 using MAX10 FPGA with TSE MAC ,SRAM and own application as client

every time need to below steps

1.open connection from client and connected to server.

2.client will get (4500 in 40 times )data from MAX 10 NIOS processor .

3.close the connection and again re-open the connection .

 

using SRAM [tristate controller ]for Stack ,heap and code ,packet memory.

 

i am getting frequent time out in one hour . but my setup as to run for long hours minimum 1 day.

listed observation when timeout times:

1.processor is going for dtrap and panic ,MAC close

2.no sync ,ack fin reply from processor [Processor is in hold state may be]

Note : if i added some delay after data send it is running for 2 -3 hours then getting timeout and errors .

 

really worried on this more than 2 months but not able to find solution for this project .help to resolve the problem and find the route cause for this.

if someone helped me it will be grate help for us team.

 

Regards

Ram.

0 Kudos
3 Replies
BoonBengT_Intel
Moderator
165 Views

Hi @sRama28,

 

Thank you for posting in Intel community forum and hope all is well.
Is there any timing constraint added to the project? Or any timing violation upon compiling? Are you able to setup the inet?
In the mean time, there are knowledge article with similar error mention here, please do have a look.

 

Best Wishes
BB

BoonBengT_Intel
Moderator
131 Views

Hi @sRama28,

 

Good day, just checking in to see if there is any further doubts in regards to this matter.
Hope we have clarify your doubts.

 

Best Wishes
BB

BoonBengT_Intel
Moderator
110 Views

Hi @sRama28,

 

Greetings, unfortunately as we do not receive any further clarification on what is provided. Hence thread will now be transitioned to community support for further help on doubts in this thread. For new queries, please feel free to open a new thread and we will be right with you. Pleasure having you here.

 

Best Wishes
BB

Reply