- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
https://www.intel.com/content/www/us/en/support/programmable/articles/000076366.html?wapkw=calibration fail : seq c
As above link suggests:
I am using Quartus prime v16.1 to program a .bin image file and the error is not resolved. Can anyone help?
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Sap
May I ask if you are using one of the devkit or you are using a custom board?
If you are using a custom board, have you change the memory size in the device tree to match with the Quartus project?
Regards
Jingyang, Teh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
'If you are using a custom board, have you change the memory size in the device tree to match with the Quartus project?'
Hi Jingyang,
Thank you for your reponse. It's a custom board. What do you mean by 'change the memory size in the device tree', do you have a screen shot to show?
I am using an altera programmer to program a custom .bin file into a custom board using Nios2 command shell
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
If you are using a custom board you could not use the GSRD that is available.
You would need to change the quartus project emif parameter and the device tree below:
Line 17 to 20
Regards
Jingyang, Teh
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page