- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I changed BIOS settings to enable Intel Rapid Start technology. Since then the display is not getting detected.
I faced these set of issues:
I reset the BIOS by removing jumper and putting it back to 1-2 position. I got the display but could not enter BIOS settings.
Later I tried removing CMOS and putting it back after 1 hour. Then I started receiving 2 beeps pause 2 beeps. Then I downloaded .BIO files of the board and started to install them one after other till latest update 327 , I have tried to install BIOS update by USB and by removing jumper. I don't know if BIOS got updated or not since there was no display. And I stopped receiving beeps also. Earlier keyboard was detecting, now that also stopped.
Hard disk seems to detect.
I have Nvidia graphics card along with onboard display, but both are not detected.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It seems to be a defective board. I was going to suggest BIOS recovery but apparently you have done it so far.
I would recommend contacting Intel customer support for warranty options at: https://servicerequestmgmt.intel.com/webticketui/emailpage.aspx Service Request Email
Allan.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page