Sygnał grafiki Intel Arc A750 wychodzi przez wyjście hdmi płyty głównej [integre]

[Czajna]

Mam problem z przekierowaniem sygnału grafiki na gniazdo pcie w którym 

zamontowana jest karta graficzna Arc A750. Podłączony kabel z integralnym złączem

działa prawidłowo. Po przestawieniu w biosie na pcie czarny ekran monitora. Monitor 

podłączony do karty graficznej .Czerwona dioda

świeci na płycie głównej.

Wypadało by podać specyfikacje- i5 13600k ,

Gigabyte Z690 UD DDR5.

[RamyerM_Intel]

Hello Czajna, 

Thank you for posting in the communities. Just to confirm, is this a newly built system? Also, I want to make sure that we are on the same page, you mentioned you switch in bios to PCIE, would you be able to show us a screenshot of this so we can check? Before the switch, does it show a display? Additionally, is the Rebar enabled in your system? To further isolate if this is an issue with the cable, were you able to use a different cable in your system as well? I will be waiting for your reply. 

Ramyer M.

Intel Customer Support Technician 

[RamyerM_Intel]

Hello Czajna, 

Were you able to seem my previous post? I am just following up about this information so we can assist you better. I will be waiting for your reply. 

Ramyer M. 

Intel Customer Support Technician

[RamyerM_Intel]

Hello Czajna, 

I hope you are doing well. As we have not heard a response in the past few days, we will proceed in closing this thread. If you need assistance in the future, please submit a new question as this thread will no longer be monitored.

Ramyer M.

Intel Customer Support Technician