Support for Intel® vPro™ software development and technologies associated with Intel vPro platforms.
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
Success! Subscription added.
Success! Subscription removed.
Sorry, you must verify to complete this action. Please click the verification link in your email. You may re-send via your
profile.
According to my practice, if the ME uses static IP mode and Gbe uses DHCP mode. The AMT system can work fine. But from the document, the IP mode is not recommended.
We dont preventthis configurationbut its not a recommended solution which could cause lot of confusion when trying to map out which device got which IP address
I suppose that someone who configure AMT/ME to use withstatic IP will change AMT hostname and wrote down that information (AMT hostname and static IP, now I have on my test machine for AMT hostname BFAMT with static ip 192.168.77.7 and for os hostname is BFCOMP and static ip is 192.168.77.8). However, even if DHCP is used for AMT/ME I suggest to change AMT/ME hostname because it is easier to distiguinsh AMT IP with changed hostname.
