Configure and Set Up the Intel® Vision Accelerator Design with an Intel® Arria® 10 FPGA

[SandeshKum_S_Intel]

From the "Configuration Guide for the Intel® Distribution of OpenVINO™ toolkit 2020.4 and the Intel® Vision Accelerator Design with an Intel® Arria® 10 FPGA SG2 (IEI's Mustang-F100-A10) on Linux", there is a note mentioning that "Intel® Arria® 10 FPGA (Mustang-F100-A10) Speed Grade 1 is not available since the OpenVINO 2020.3 release".

Is there a way(any linux command/utility) to check if the FPGA card being used is SG1 or SG2 ?

PFA o/p of the card being used:

$ lspci | grep -i Altera

01:00.0 Processing accelerators: Altera Corporation Device 2494 (rev 01)

[Munesh_Intel · Accepted solution]

Hi Sandesh,

Please refer to the product label on the fan cover side or by the product SKU:

Mustang-F100-A10-R10 => SG1; Mustang-F100-A10E-R10 => SG2

Regards,

Munesh

[Munesh_Intel]

Hi Sandesh,

Intel will no longer monitor this thread since we have provided a solution. If you need any additional information from Intel, please submit a new question.

Regards,

Munesh