- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This in inquiry about EII install. I can't install eii installr as atachement.
Could you tell me which file I should check to how to write the following.
↓
# Please populate the below EII DB and UI credentials needed for EII installation. Based on the EII services
# coming up, the below credentials would be used
etcdroot_password:
influxdb_username:
influxdb_password:
minio_access_key:
minio_secret_key:
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi yi15,
These are values you are defining, Influxdb username and password are used to initialize the database in the datastore microservice. Additional information can be found here: https://eiidocs.intel.com/4.1/pages/getting-started-guide.html#step-4-configure-your-installation
Regards,
Jesus
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi yi15,
Thanks for reaching out, the values need to be specified in ~/edge_insights_industrial/config_install.yml. It should be located in the same directory as the edgesoftware binary. In the screenshot above, you are displaying the content of config_install.yml file, just complete the lines.
For example:
etcdroot_password: 'password'
influxdb_user: 'user'
...
Regards,
Jesus
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Jesus,
Thank you for your reply. To set value in ~/edge_insights_industrial/config_install.yml, Shoul I get influxdb_user and pass for third party ? Or Is there this value in other files?
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi yi15,
These are values you are defining, Influxdb username and password are used to initialize the database in the datastore microservice. Additional information can be found here: https://eiidocs.intel.com/4.1/pages/getting-started-guide.html#step-4-configure-your-installation
Regards,
Jesus
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for your support.
I remembered that etcd password is optional but EIF requires this password as mandatory. Or May I set the blank as "" ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you need any additional information, please submit a new question as this thread will no longer be monitored.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page