- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey,
I couldn't find a clear answer browsing forums/datasheets, so I might ask there :
- I have Quartus Prime Standard Edition 18.0
- I have Modelsim Intel FPGA Starter Edition 10.5b
Is it possible in this case to simulate a design including IP requiring a license, such as ethernet, transceivers modules, or in my case jesd204b module, without its license (so called Evaluation Mode) ?
Or do I need to have a licensed Modelsim in order to run simulations with this evalution mode ?
Thanks for enlightening me !
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi RLedu,
You may need to request evaluation license to evaluate the IP, jesd204b module.
You may refer here :
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear RLedu,
Thank you for contacting Intel Community Forum.
We have review your issue. Please allow us some time, we will reply to your issue shortly.
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi RLedu,
You may need to request evaluation license to evaluate the IP, jesd204b module.
You may refer here :

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page