Intel® Moderncode for Parallel Architectures
Support for developing parallel programming applications on Intel® Architecture.
Announcements
Welcome to the Intel Community. If you get an answer you like, please mark it as an Accepted Solution to help others. Thank you!
1685 Discussions

Specifying alternate ports using Remote Data collector

Maximillia_D_Intel
110 Views

Hello,

I'm trying to use an alternate port under remote data collector and Thread Profiler.

The command on ittserver is:
ittserver -p

ittserver starts up fine and tells me it is using the alternate port, however do I need to do something on the Windows host side? Itriedjust by specifying the IP without port and it did not seem to work - the host could not connect.
I tryadding the port by appending : to the end of the ip, so for me:
10.23.29.176:50004 andVTunedoesn't like the syntax.

I am using Fedora Core 5and at least on my system, the default port, 50002 is in use by something else.

Any help is appreciated.

Thanks,

Max

0 Kudos
1 Reply
Victor_Zaguskin
Beginner
110 Views
Thread profiler RDC does not support alternative ports.

Regards,
Victor
Reply