Adding components to reference QSYS design, exported pins don't show up

Intel® Quartus® Prime Software

Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)

Adding components to reference QSYS design, exported pins don't show up

1,188 Views

Hi all,

So I've been working with the Cyclone V GT dev kit, using a reference PCIE design provided on the altera wiki: http://www.alterawiki.com/wiki/reference_design:_gen2x4_avmm_dma_-_cyclone_v

The base design works as intended, but I want to build a module to interface with on chip memory as well as external pins that will be providing inputs to the system. The problem I'm having is when I build a new QSYS component, add it to the reference system, and then export its conduit signals, they don't show up by default in the pin planner after analysis and synthesis. Is there a specific step that needs to be taken to cause a top level qsys exported signal to show up in the pin planner list?

Any ideas?

Thanks,

Nit

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.