Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
17268 Discussions

Flex&QuartusⅡVer9.0 [JTAG chain problem detected]

Altera_Forum
Honored Contributor II
‎09-06-2017 05:14 AM
1,409 Views

Hello, 

Please refer to attached file. 

 

I have a FlexSeries[EPF6024AQC240-2&EPC1441PCB] on Board,USB Blaster,Quartus software Ver9.0,Install Program[pof file&sof file] 

 

And I want to Install Program file to [EPF6024AQC240-2&EPC1441PCB]. 

But appear error. 

Error:JTAG chain problem detected 

Error:No device detected 

Error:The TD0 connection to the download cable might be shorted to GND or is an open circuit 

Error:The TCK and TMS connections to the last device might have problem 

 

Maybe It's in the state that ,can't communicate. 

Is special setting needed there? 

 

Please give me your advice.
Preview file
489 KB
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.