Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
15677 Discussions

I would like to ask about the PDN(Power Distribution Network) tool. I am using a Cyclone 10LP FPGA and I couldn't find that version in the tool. I noticed the PDN supports Cyclone 10 GX FPGAs, can I use that version for my FPGA or should I look elsewhere?

LKauf1
Beginner
1,125 Views
0 Kudos
4 Replies
Vicky1
Employee
251 Views

Hi,

For the Intel Cyclone 10 LP devices you may use the Device Agnostic Power Delivery Network (PDN) Tool, refer the below solution link & training.

https://www.intel.com/content/altera-www/global/en_us/index/support/support-resources/knowledge-base...

https://www.intel.com/content/www/us/en/programmable/support/training/course/opdn1105.html

 

Let me know if this has helped resolve the issue you are facing or if you need any further assistance.

 

Best Regards

Vikas Jathar 

(This message was posted on behalf of Intel Corporation)

 

FLuqu
Beginner
251 Views

The training course page seems to be down. Could you please recheck & post the updated link?

LKauf1
Beginner
251 Views

Thank you for you answer. Can I still use the device specific tool for Cyclone GX as a starting point for board design with 10 LP since that tool is more accurate?

Vicky1
Employee
251 Views

Hi,

For the Intel Cyclone 10 LP devices I would recommend to use the Device Agnostic Power Delivery Network (PDN) Tool,

PDN.JPG

Please refer the below links,

https://www.intel.com/content/www/us/en/programmable/support/support-resources/support-centers/signa...

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_pdn.pdf

 

Best Regards

Vikas Jathar 

(This message was posted on behalf of Intel Corporation)

 

 

Reply