Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
17255 Discussions

In-system Memory Content Editor causes ERROR 15684

Altera_Forum
Honored Contributor II
‎06-09-2015 01:22 AM
1,354 Views

When generating a 1-port RAM in MegaWizard, If I enable the "In-system Memory Content Editor" I get the error message: 

 

"Error (15684): M4K memory block WYSIWYG primitive "monitoring_RAM:mod_monitoring|altsyncram:altsyncram_component|altsyncram_asc1:auto_generated|altsyncram_t682:altsyncram1|ram_block3a1" utilizes the dual-port dual-clock mode. However, this mode is not supported in Cyclone II device family in this version of Quartus II software. Please refer to the Cyclone II FPGA Family Errata Sheet for more information on this feature." 

 

I get no errors when I disable the Memory Content Editor.  

 

What's weird is that I compiled an old project, same HW, which had a MegaWizard ram and it works fine. So I doubt the part of the message "is not supported in Cyclone II device family in this version of Quartus II software". 

I couldn't figure out what setting(s)/option(s) I need to change. They both seem to have similar setup.  

 

I am using Quartus 13 with Cyclone II on DE2. 

 

Any thoughts on how to resolve that? 

 

-Best
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.