Integrating a HAL Device Driver in the BSP

Intel® Quartus® Prime Software

Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)

Integrating a HAL Device Driver in the BSP

1,315 Views

Hello! I am sorry for my english.

I use Cyclone IV GX Transceiver Starter Kit Board. I took the Qsys project from an example project(c4gx15_starter_bup) as a basis for my project. In Qsys project, I only excluded sgdma_tx - rx, tse_mac and descriptor_memory. The more I have not changed anything in the project. Then I added the drivers for the tristate_lcd and maxII_interface in project folder, as it is written in "AN 459: Guidelines for Developing a Nios II HALDevice Driver". Then I created new aplication and bsp project for Nios and drivers did not add. In the BSP editor, they are not visible. How add them in the project? Help me, please

Link Copied

0 Replies

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.