- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello! I'm interested in some special modes of PLL operation thus I want to simulate different cases in Modelsim. However PLL just not working inside Modelsim Starter Edition 10.5b for Cyclone 10 LP. Test project attached to this post, just fix path and run sim.bat.
I tried many advices: hold reset for a longer time, simulate hundreds of ms, set more precision with timescale 1ps/1fs and so on. Still out of luck.
Is there any known bugs?
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There are mistake in my code, line should be .inclk0(clock). But nevertheless, outputs still Z, PLL model not working at all. What I doing wrong?
Updated code: https://pastebin.com/mEUZSk27

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page