Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
17268 Discussions

Modelsim6.4 se Edition Error

Altera_Forum
Honored Contributor II
‎11-10-2008 02:41 PM
1,109 Views

Hi 

I am getting error, while compiling the design files from .do file with ModelSim SE 6.4 in windows. Error message as follows. 

# ** Error: (vcom-7) Failed to open design unit file "F:/code/aes/pack.vhd" in read mode.# No such file or directory. (errno = ENOENT)# ** Error: C:/modeltech_6.4/win32/vcom failed. 

 

But I am able to compile the same file by direct loading. Whatever do file I using was working fine for ModelSim 5.4E.  

 

 

Any suggestions will be appreciable. 

 

Thanks In Advance 

 

Prakash Kumar.T 

http://www.alteraforum.com/proweb/buttons/quote.gif (http://www.alteraforum.com/forum/newreply.php?do=newreply&p=15436)
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.