Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
17255 Discussions

Problem simulating devices with bus hold pins

Altera_Forum
Honored Contributor II
‎09-03-2010 01:30 PM
1,316 Views

I have a device I'm simulating with Altera-ModelSim which has a bidirectional bus with the bus hold attribute set on it. The simulator is unable to override the weak bus hold drive even when strong drive strengths are specified in the test bench. If I remove the bus hold attribute the simulator can drive the bus as expected. I need the bus hold attribute in my design so removing it isn't an acceptable work around.

0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎03-22-2011 01:41 AM
461 Views

same issue with stand-alone Modelsim SE. Any workaround from Altera yet?

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.