Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
16596 Discussions

Programming Using Command Line

MHamz1
Beginner
‎07-08-2019 12:20 PM
452 Views

HI,

I am using the following command to program the CPLD from command line

start quartus_pgm -z --mode=JTAG --operation="p;C:\Test Firmware\CPLD_U1.pof@1"

It runs the quartus_pgm and exits on success or failure. I am unable to view the output as it quits immediately.

Can anyone suggest me a way to look if the programming was successful or not and how to read the output of quartus_pgm

0 Kudos

Link Copied

0 Replies
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.