Quartus II Programmer fails with message: CONF_DONE pin failed to go high in device 1

Intel® Quartus® Prime Software

Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)

Quartus II Programmer fails with message: CONF_DONE pin failed to go high in device 1

2,378 Views

I am trying to uploa .sof file (of DE2 control panel) to DE2 board (that uses Cyclone II family EP3C16F484)

I am using Quartus II 13.0sp1 in an Asus S46C Ultrabook with Windows 8 64 bit.

I use Quartus II (64 bit) Tools/Programmer and standalone Altera Programmer (32 bit) with same results, with the messages:

Error (209014): CONF_DONE pin failed to go high in device 1

Error (209012): Operation failed

I tried other .sof files from examples without success.

I tried in a Windows 7 machine with Quartus II 10.0 with the same results.

http://www.alteraforum.com/forum/attachment.php?attachmentid=10429&stc=1

Airton da Fonseca Granero

19 KB

Link Copied

0 Replies

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.