Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
公告
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
17268 讨论

Trouble connecting from FS2 console to device thru USB blaster

Altera_Forum
名誉分销商 II
1,171 次查看

I've been asked to debug fallout of some of our units. 

I am attempting to using the FS2 console to initiate reads and writes and otherwise exerciseEP4CE10F17I7N. 

However, I've been stumped with the following: 

 

System Analyzer for Nios® II Processor 

Serial number  

Version 1.9.6 build 3 

Copyright (C) 1998-2005 First Silicon Solutions, Inc. 

Communication port must be specified. 

Use openport <port> to configure the communication port 

detect_trigger length trigger error 

No Memcache range available: Communication has not been established with remote unit. 

cd c:/altera/91/nios2eds/examples 

1> closeport 

2> openport usb 

No available FS2 products found on USB port. 

3> 

 

How do I get the FS2 to recognize the usb blaster that is seen by the Nios2 console? 

This is the first time I have tried to use the Quartus/Nios/FS2 software to do this so I am suspecting I have a configuration issue, but what is it? 

 

Thank you in advance,
0 项奖励
0 回复数
回复