- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I recently installed a fresh version of Quartus Prime Lite 18.1 on Linux. I have a Cyclone 10LP development kit and am trying to compile one of the example projects included. I have compiled the same project on a previous install so I know it works. No other warnings.
I am getting an error from the EDA Netlist Writer:
Error (20268): Functional simulation is off but it is the only supported netlist type for this device.
I have never modified any netlist types and haven't found any info online or looking through some Quartus manuals or through the software.
All suggestions and feedback are appreciated. Thanks
- Tags:
- compilation
- linux
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Update: I have continued searching and have found a documented list of a deeper explanation of all the error codes produced by the standard Quartus synthesis process. Error code 20268 is not listed.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Vicky,
Thanks for the suggestion. I removed the db and incremental_db directories and attempted a recompile and received the same results.
I will try to roll back to 18.0 to see if it is an update issue.
Thanks,
-Taylor
** Update: The same program will compile as expected on v18.0. I will continue using v18.0 until I see something about it in a future release.
![](/skins/images/45C6C2D737ED71F4C51F0145C8CB1E9C/responsive_peak/images/icon_anonymous_message.png)
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page