lvds simulation of stratix 4 using cst design studio

Intel® Quartus® Prime Software

Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)

lvds simulation of stratix 4 using cst design studio

1,562 Views

Hello,

In attachment you can find a printscreen of my simulation setup, and results.

I used the ibis model (lvds25_ro_p0_v0) of the stratix 4 downloaded from the site.

The excitation signal of port 1 is a pulse of 50Mhz 2.5V in amplitude.

I connect the output of the ibis model to a 50R termination resistor to ground.

I would expect an output wave of 1V to 1.4V, because these are the levels of lvds (of one single ended net)

But as the graph shows, I get an output of approx. 0 to 1V.

So my conclusion is that there is something terribly wrong in my setup :-)

and I can't figure out what it is.

Any suggestions?

Thx,

Tim

387 KB

Link Copied

0 Replies

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.