Intel® Xeon® Processor and Server Products
Intel® Xeon® Processors, Data Center Products including boards, integrated systems, and RAID Storage
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.

S3000AH no boot?

idata
Employee
2,692 Views

I have an S3000AH board that stopped working after a Windows disk cleanup procedure. On power up the LED Diagnostics stop at |OFF|Red|OFF|Red| and the system goes no further. The manual indicates this means "Enumerating PCI Busses." I have removed the Raid controller and the same error occurs. Is this board dead?

Thanks!

0 Kudos
4 Replies
Daniel_O_Intel
Employee
1,043 Views

Possibly. Can you unplug the NICs, and remove anything else that might be on the PCI bus? Any USB devices?

0 Kudos
idata
Employee
1,043 Views

Nothing else is connected to the board. I removed the RAID card as well with same result. I pulled the memory out as well to see if it would beep and it did.

Daniel_O_Intel
Employee
1,043 Views

Weird. Normally I'd say that's a dead board, but that would never be caused by just running a software program.

0 Kudos
idata
Employee
1,043 Views

Found a used board on Ebay for $55. Swapped it out and everything works now. Old board is now a target for my .45 ACP practice.

What a bargain!

Thanks

0 Kudos
Reply