- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
Apologies for a noob question.
I have a D430 depth sensor, D4 vision processor board and D400 50-pin interposer. However, I am not able to figure out the interconnections or the cable required to connect them together.
I like to use this system in an identical fashion to the D435 camera. I am hoping to connect the D430 camera to the D4 vision process via the interposer. Then connect to the host PC running linux using type C USB.
Does this require PCB design skills. Any help here will be highly appreciated.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is it the Rigid Interposer board that you have, please?
If so, you should not need a cable to connect the Vision Processor D4 board and the D420 camera module board together. The Rigid Interposer acts as a solid bridge between the two boards.
One end of the Rigid Interposer should plug onto the matching 50 pin connector on the D420 board. The other end of the Interposer should plug onto the matching connector on the top of the D4 board.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is it the Rigid Interposer board that you have, please?
If so, you should not need a cable to connect the Vision Processor D4 board and the D420 camera module board together. The Rigid Interposer acts as a solid bridge between the two boards.
One end of the Rigid Interposer should plug onto the matching 50 pin connector on the D420 board. The other end of the Interposer should plug onto the matching connector on the top of the D4 board.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks MartyG
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page