- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What is the type of the mounting hole of the realsense sr300?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Are you referring to the alignment holes, please?
If you are seeking the size of the tripod thread hole on the bottom of the camera, it is a standard 1/4"-20 tripod thread size.
The full data sheet document for the SR300 camera can be found at the link below:
https://www.intel.com/content/www/us/en/support/articles/000023535/emerging-technologies/intel-realsense-technology.html
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Are you referring to the alignment holes, please?
If you are seeking the size of the tripod thread hole on the bottom of the camera, it is a standard 1/4"-20 tripod thread size.
The full data sheet document for the SR300 camera can be found at the link below:
https://www.intel.com/content/www/us/en/support/articles/000023535/emerging-technologies/intel-realsense-technology.html
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you.
What I want is the size of tripod thred hole.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you. It is a standard 1/4"-20 size.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page