Intel® Core™ processors, Intel Atom® processors, tools, and utilities
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
Success! Subscription added.
Success! Subscription removed.
Sorry, you must verify to complete this action. Please click the verification link in your email. You may re-send via your
profile.
You should make sure you have an adequate cooling system and ventilation. If you installed the processor yourself, you should make certain the paste is applied correctly.
This temperature is at the top of the normal control range; high but not concerningly high. As Al indicated, you have control over the installation of the thermal control system for the processor and the effectiveness of its ability to dissipate heat from the processor (i.e. the TIM used between processor heat spreader and solution's thermal mass). The actual control of the cooling fan(s)/blower(s)/pumps available in the system is a platform-level function and is normally configured from the motherboard's BIOS. BIOS Setup should offer you scenes for managing the thermal control curves, etc.
