Configuring u-Boot for Custom Board with Arria 10

Nios® V/II Embedded Design Suite (EDS)

Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++

Configuring u-Boot for Custom Board with Arria 10

1,350 Views

Hi,

I am using a Custom board with Arria 10 SoC. It has peripherals QSPI Flash,eMMC,TPM via I2c, FRAM, etc. I plan to test these peripherals using u-boot commands. But the defconfig for arria10 doesn't have any of these. How can build u-boot to test these? I have installed SoCEDSProSetup-17.0.0.290-linux in linux host machine. Created handoff file of my board and using bsp-editor generated the software with 'diasble u-boot build' unchecked. But whenever I try in the emmbedded_command_shell, it is using defconfig for u-boot building even if i modify in menuconfig. can you advise me how to enable all peripherals in my u-boot binary ?

Link Copied

0 Replies

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.