Driving external ADC in Nios II Eclipse

Nios® V/II Embedded Design Suite (EDS)

Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++

Driving external ADC in Nios II Eclipse

1,076 Views

Hi, recently i've been working on a project "digital oscilloscope" using lcd monitor as display via vga port which mainly uses Altera DE1 board, Altera Quartus II, Nios II and Qsys.

I'm using MCP3002 as my oscilloscope ADC.

I'm referring to an 8-bit parallel ADC codings to make modification on my codings. But it's too complicated for my level of understanding.

I try to change the 8 bit parallel settings to 10 bit format, but for calculation wise, i'm not too sure about "do i need to change".

I only know that for 8 bit parallel can just get 1 output for one point, and get multiple points to form a line or curves.

For serial ADC, the conversion need to w8 for the adc to receive 10 bits output only can proceed to conversion and display.

But, I have no idea how to carry out, can anyone help me on my code?

Thank you.

6 KB

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.