Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
FPGA community forums and blogs on community.intel.com are migrating to the new Altera Community and are read-only. For urgent support needs during this transition, please visit the FPGA Design Resources page or contact an Altera Authorized Distributor.
12748 Discussions

How can I access the U-Boot command line in my DE0-Nano-SoC board?

Altera_Forum
Honored Contributor II
‎12-05-2017 04:38 PM
1,539 Views

I have DE0-Nano-SoC running pre-compiled Linux (I'm new to the whole Linux compiling and booting - it's really overwhelming :() 

I want to assign a certain size of the RAM for the Linux Kernel. I read that to do this, I must either type some commands in the U-boot command line or using the U-boot script. 

 

My question is how can I access the U-Boot command line in my DE0-Nano-SoC board. 

 

Thank you very much in advance.
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.