Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12723 Discussions

How to use JTAG UART with normal UART in a Qsys System

Altera_Forum
Honored Contributor II
1,808 Views

I have included a JTAG UART and a normal UART into my system. The JTAG UART shall be eventually removed but must be used for the time being. As far as I understand, I should merely goto the BSP editor settings and choose which of the two are to be used for stdin, stdout and stderr. 

 

Now, basically when I choose the uart_0 in BSP editor and try to run my design I get the this message: 

"The expected Stdout device name does not match the selected target byte stream device" 

 

I have explicitly select uart_0. What does this message mean then when it says "expected Stdout device"?
0 Kudos
0 Replies
Reply