- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello ,
I am having a project where I need to take control of a pc or a smart phone which has a VNC server using FPGA so I need to run a client from the FPGA side . Is this possible ? My kit is the de2-115 .It has USB controller chip and Ethernet connections .Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Well, you can run Linux on NIOS on that board.
So you might be able to run a VNC client too.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is there a way to know the capabilities or features of NIOS Linux and how far can it go ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
--- Quote Start --- Is there a way to know the capabilities or features of NIOS Linux and how far can it go ? --- Quote End --- How far in what direction ? It can run any Linux program (including any graphic stuff), so anything goes. Any I/O hardware (including graphics) can be created in VHDL code and be accessed by appropriately done Linux drivers, so anything goes, but it might be a lot of work. Software performance is not very fast, so you are limited. -Michael
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page