Nios® V/II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12604 Discussions

NiosII JTAG Debug - Hardware Triggers

Honored Contributor II



In Altera's document "n2cpu_nii5v1.pdf", under JTAG Debug Module, there is section called "Hardware Triggers", page 2-21. 


Question 1) 

Can this feature be used for detecting if value on specific memory address is changed to some other specific value? (In doc. is mentioned that Trigger conditions on the same bus can be logically ANDed, so probably answer is yes but I need confirmation). 


Question 2) 

How to use this feature? Standard "watch" command from gdb can only monitor if there is read, write or read/write access to some specific memory address.. 


0 Kudos
0 Replies